Save $50 on SoClean 2 plus Free Shipping. Try it risk free Buy Now

CREATE ACCOUNT

Setting up the SoClean with ResMed AirSense 10

It’s easier than ever to sanitize your ResMed AirSense 10 with the appropriate SoClean CPAP adapter and any SoClean model. Simply remove the original lid, replace it with the appropriate SoClean adapter lid, and attach the injection hose. Cleaning your ResMed AirSense 10 is a snap!


STEP ONE

Detach the injection fitting and short hose from the main SoClean hose
You will no longer need the injection fitting and short hose.


STEP TWO

Remove the original lid from the reservoir base by opening the lid fully, pushing one side of the hinged tab outward and freeing the lid from the base.


STEP THREE

Lift the gasket from the original lid and transfer it to the SoClean adapter lid.


STEP FOUR

Install the SoClean adapter lid with the black injection hose to the reservoir base by inserting the left pin into the left notch. Pull the lid toward you and insert the right pin into the right notch. If needed, refill your reservoir.


STEP FIVE

Close the SoClean adapter lid and insert the reservoir into your CPAP unit
like you normally would.


STEP SIX

Connect the main SoClean hose to the adapter by pushing it onto the the stem on the adapter lid. When you need to add water to your reservoir, please remove the main SoClean hose from the adapter lid and remove the reservoir for the CPAP machine. Add water and reinsert into the CPAP machine and then reconnect the SoClean hose.Warning: Hose must be attached to the adapter lid at all times when using the SoClean.

That's it! You are now ready to use the SoClean.

TOP